3M has a product called Windo-Weld, part number 51135 08612, it is a Ribbon Sealer Auto Glass Replacement Kit.
I still have some from a kit I purchased in 2001, cost then was $11.00 for 15 feet by 3/8 inch thick.
You have to clean the glass really good, I use a silicone primer and clean the plastic on the hatch and I use a product called Grows Super Clean, to clean the plastic. Then lay out the windo-weld and set the glass in it. And your done. Some like to put a U shaped rubber seal around the glass before placing it on the hatch but they still had to use the windo-weld on the back side and edge for a good fit.
Bill
> -----Original Message-----
> From:
> 2cylinderhondas@yahoogroups.com [mailto:2cylinderhondas@yahoogroups.com] > On > Behalf Of > Steven Michelsen > Sent:
> Wednesday, February 11, 2009
> 4:46 PM
> To:
> 2cylinderhondas@yahoogroups.com
> Subject:
> Re:
> [2cylinderhondas] Copue Hatch Glass
> I wonder, how was hatch glass installed at the
> factory? Mine is glued in; photos I have seen suggest that most are > these days.
> Steve
> www.honda600coupe. com
> > ----- Original Message -----
> > From:
> > scott
> > lesniak
> > To:
> > 2cylinderhondas@ yahoogroups. com
> > Sent:
> > Wednesday, February 11, 2009 7:37
> > PM
> > Subject:
> > Re: [2cylinderhondas] Copue
> > Hatch Glass
> > You will have to take it to your local windshield place and they > > can urethane it in place .
> > Do not do it yourself unless you have glass primer or it will > > fall out ,the glass is ceramic coated and it will fall out if you > > don't use primer.
> > also the so called primerless urethane will not work either.. I > > just had mine done and it cost $10 bucks > > --- On > > Wed, > > 2/11/09, Dave > >
> > wrote:
> > > From: Dave
> > >
> > > Subject: [2cylinderhondas] Copue
> > > Hatch Glass
> > > To:
> > > 2cylinderhondas@ yahoogroups. com
> > > Date: Wednesday,
> > > February 11, 2009, 6:47 PM
> > > I have a near perfect hatch for a coupe. I also have a piece of > > > factory > > > glass to put into the hatch. I have the service and > > > parts manual but > > > can't figure out what holds the glass into the > > > hatch. I would > > > appreciate some help with this,thanx.
> > > Dave
> > > Kohn
> > > Long
> > > Island,NY