Need help picking replacement weather stripping for n600 doors.

[dawn_and_darrian]

I'm looking to replace the weatherstripping around my doors on my sedan, but am unsure which is the best to use.
Please see the attached link:
http://www.jcwhitney.com/autoparts/Prod ... er%20strip
Have any of you used this jcwhitney stripping before?  If so, which did you use?

[isettajoe]

--- In 2cylinderhondas@yahoogroups.com, "Matt Timion" wrote:

> I'm looking to replace the weatherstripping around my doors on my

sedan, but am unsure which is the best to use.

> Please see the attached link:
http://www.jcwhitney.com/autoparts/Prod ... stom-0/Pr-

p_Product.CATENTRY_ID:2008597/c-10101/Nty-1/p-2008597/Ntx-
mode+matchallpartial/N-10101/tf-Browse/s-10101/Ntk-AllTextSearchGroup?
Ntt=push%20on%20weather%20strip

> Have any of you used this jcwhitney stripping before? If so, which did you use?

I got weatherstripping from Mings and put it in last fall. It had the
bulb shape like Type 2 in your picture. It fit fine, easy to push on,
except for along the bottom of the opening, where your interior
plastic trim gets in the way. I cut the back part of the weatherstrip
off so it would have the same thickness as the rest, so the door would
shut against a flat plane all around. I have yet to glue the bottom
part on due to cold weather. I did try one kind of glue and found
that it was so sticky I could not get the tube away from the body
without getting stringy bits of glue as I pulled away. I found some
other glue that didn't pull away stringy, and I plan to use that when
the weather warms up.