THIS @#$\%^&*()+ bolt I can'tget at it!!

[riceburner006]

Is there a mystery tool,or trick to getting a wrench on that 12mm
clutch arm adjusting bolt? I tried many ideas,such as using a
shorter bolt or a sedan 10mm head seat bolt!

[dealadayray]

Not to give away any secrets, but a 12 point box end 12mm wrench is what I
use. Although I have worked on 600's that had a hole drilled into the body
to allow a wrench to fit through. Worked real well, it also had a rubber
plug in it to keep it clean.
Bill

[Steve]

That bolt in the clutch arm is hardened steel, I don't reccommend
putting another in it's place. If you remove the heater blower it is
very easy to adjust the clutch from the top.
Miles

--- In 2cylinderhondas@y..., "william colford" wrote:
> Not to give away any secrets, but a 12 point box end 12mm wrench is
what I
> use. Although I have worked on 600's that had a hole drilled into
the body
> to allow a wrench to fit through. Worked real well, it also had a
rubber
> plug in it to keep it clean.
> Bill
> ----- Original Message -----
> From: "riceburner006"
> To:
> Sent: Saturday, November 30, 2002 12:07 AM
> Subject: [2cylinderhondas] THIS @#$%^&*()+ bolt I can'tget at it!!
> > Is there a mystery tool,or trick to getting a wrench on that 12mm
> > clutch arm adjusting bolt? I tried many ideas,such as using a
> > shorter bolt or a sedan 10mm head seat bolt!
> > To unsubscribe from this group, send an email to:
> > 2cylinderhondas-unsubscribe@y...
> > Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/