Gas filler neck leak

[club_hondafr]

Hi all, I think I have discovered a pinhole leak in my N600's tank filler neck. Is that repairable without major surgery?
Thanks,
Jayson

[dusty path]

Jason  it matters were the little  hole  is  but   I clean  the hole use JB weld   if its a small hole
On Friday, May 26, 2017 7:01 PM, "Jayson Allen jayson_allen@... [2cylinderhondas]" wrote:
Hi all, I think I have discovered a pinhole leak in my N600's tank filler neck. Is that repairable without major surgery?
Thanks,
Jayson

[Chuck Dean]

+1 on the JB Weld. I was thinking exactly the same thing.
Chuck (mobile) Pleez x cuze enny tie ping or spelin air ores.
Our 1972 Honda 600 Coupe

On May 27, 2017, at 3:53 AM, dusty path
dustyspath@...
[2cylinderhondas] wrote:
Jason  it matters were the little  hole  is  but   I clean  the hole use JB weld   if its a small hole
On Friday, May 26, 2017 7:01 PM, "Jayson Allen
jayson_allen@...
[2cylinderhondas]" wrote:
Hi all, I think I have discovered a pinhole leak in my N600's tank filler neck. Is that repairable without major surgery?
Thanks,
Jayson

[club_hondafr]

I think I solved it. I HOPE I solved it :)
Not a leak but rather a disconnected breather hose. Noticed the leak when filling... a drip from the rocker weep hole near the full neck. Pulled the interior and found this. No wetness on the neck itself. Crossing fingers that there is no actual leak.
Any thoughts if a sharp right turn is enough to slosh fuel up and out the breather spout? Is the tank baffled? Did notice a gas smell while driving too but this was before I discovered the drip when filling.
-Jayson

On May 27, 2017, at 04:07, Chuck Dean
cadean329@...
[2cylinderhondas] wrote:
+1 on the JB Weld. I was thinking exactly the same thing.
Chuck (mobile)
Pleez x cuze enny tie ping or spelin air ores.
Our 1972 Honda 600 Coupe
On May 27, 2017, at 3:53 AM, dusty path
dustyspath@...
[2cylinderhondas] wrote:
> Jason  it matters were the little  hole  is  but   I clean  the hole use JB weld   if its a small hole
> On Friday, May 26, 2017 7:01 PM, "Jayson Allen
> jayson_allen@...
> [2cylinderhondas]" 2cylinderhondas@yahoogroups.com
> > wrote:
> Hi all, I think I have discovered a pinhole leak in my N600's tank filler neck. Is that repairable without major surgery?
> Thanks,
> Jayson

Note: 1 image(s) originally linked in this post are no longer available (cid:AB5C6841-3133-40ED-9873-835E1B8C358E).

[Bill]

This is the way things are supposed to go.  There should be no smell in the seating area.   If one hose is bad, normally there are others.

Note: 1 image(s) originally linked in this post are no longer available (cid:image001.jpg@01D2D6F4.73B260C0).